ECP EVAC Parts for the RX1/RXWARRIOR
Napa Auto Parts Store Part
Numbers:
(2) # 9934 5/8 tees
(2) #9924 5/8 elbows
(2) 630-1079 grommets
(2) 605-1372 drain
(2) 10078 hose
Couple inches of elect tapeInstall:
Its going to sound more complicated than it is drill 2 7/8 inch holes in
center of filters-insert grommets install elbow in each grommet-point the
open ends towards each other install 2 pieces of the hose 2/38 inch long
each on end of elbow and insert a tee fitting to join them-put a piece of
hose 3 1/2 inches long on bottom of tee and add another tee on bottom of the
3.5 inch hose-make an end of the tee point to the clutch side and one end
point down-put a 5 inch piece on bottom of the tee and insert drain plug-put
larger 3/4 inch side of preformed hose on crank vent and cut and connect the
other end to the tee pointing towards the clutch and that should be it.
BY:Dynarex1
Totallyamaha is not responsible for any damages that these modifications may
cause to your vehicle; any modifications are your responsibility if you choose
to do so. We are providing information ONLY. Some of these modifications may
VOID your warranty and that is your responsibility to look into. The
Totallyamaha users have passed along most of the information found on this site.
If you have any questions or concerns about anything on this site talk to your
dealer before using any of the information. Totallyamaha will not be liable for
any damages or personal injury from any modification performed from this site.
