Carb Float Adjustment
For Triples take the carbs completely off the snowmobile. Remove the float bowls. Holding the carbs by the rack. Looking at the carbs inlet needles and rotate the carbs tell the float lightly rests on the needle (Aprox. 45 degrees). Measure from the float bowl gasket surface to the top or highest most part of the float. Be sure to measure at both outer edges to make sure its straight or even. If its out of spec pry or bend very carefully the tab that rides in the center of the float to adjust the height. You might have to twist it to make it even on both sides of the float. After spec has been set, reassemble carbs.
For Twins take the carbs completely off the snowmobile. Remove the float bowls. Holding the carbs by the rack rotate tell the float is up or the Carbs are upside down. Measure from the float bowl gasket surface to the top or highest most part of the float. Be sure to measure at both outer edges to make sure its straight or even. If its out of spec pry or bend very carefully the tab that rides in the center of the float to adjust the height. You might have to twist it to make it even on both sides of the float. After spec has been set, reassemble carbs.
From NCY_SRX
Any questions feel free to email the Webmaster.
Totallyamaha is not responsible for any damages that these modifications may cause to your vehicle; any modifications are your responsibility if you choose to do so. We are providing information ONLY. Some of these modifications may VOID your warranty and that is your responsibility to look into. The Totallyamaha users have passed along most of the information found on this site. If you have any questions or concerns about anything on this site talk to your dealer before using any of the information. Totallyamaha will not be liable for any damages or personal injury from any modification performed from this site.
